Remove a connection

This topic describes the procedures to remove the configuration that is performed by the setup wizard.

Steps

1. Click the Disconnect button under the Connect IBM Security Verify in to Verify Access heading to launch the setup wizard dialog.

2. Provide the Administration Hostname for the IBM Security Verify subscription used during the setup.

3. Click the Login to IBM Security Verify button. A new browser tab opens to the login page of the IBM Security Verify subscription. Complete the login by using an account which has administrative entitlements. When the login is successful, the browser tab closes and the setup wizard continues. The setup wizard indicate the login to IBM Security Verify is successful.

4. Click the Next button to continue.

5. Provide the following information to the setup wizard:

   WebSEAL Instance

   Select the Reverse Proxy instance that was previously chosen during setup.

6. Click Configure to continue. The Local Management Interface now removes the application definition created during the setup on IBM Security Verify and reverses the changes that is made to the Reverse Proxy instance. When this process is complete, the wizard will automatically advance to the Success page. The Success page is displayed.

7. Click Close to end the setup wizard.

Parent topic: Connect IBM Security Verify to Verify Access