Configuring the PC to use the new console type when changing from a local console directly attached to a local console on a network
To change from an Operations Console with local console directly attached to a local console on a network (LAN), configure the PC to use the new console type.
Follow these steps on the PC:
- Disconnect the current console connection. To disconnect, do the following:
- Select the configuration name (under iSeries™ Connection). This is the name that Operations Console uses to refer to a specific system.
- From the Connection menu, click Disconnect. The connection status shows Disconnecting.
- Wait for the status to show Disconnected.
- Configure the new console type. It is preferred that you perform an initial program load (IPL) to be certain there are no errors.
Once you are satisfied that the new console is working correctly, you can proceed with any plans to move or remove any adapter or configurations.
If you do not use the cabled connection as a backup console, you can remove the console cable, the remote control panel cable, or both cables from the PC at this time. To avoid potential errors, turn off the system before removing or adding cables from the system.
To delete the current configuration if you will not be using the cabled connection as a backup console, do the following:
- Select the configuration name (under iSeries Connection).
- From the Connection menu, click Delete.
- Click Yes to confirm the deletion.
It is preferred that you turn off the system when removing adapter cards or cables.
Parent topic:
Changing from a local console directly attached to a local console on a network (LAN)
Related concepts
PC preparations for Operations Console