Graphical server monitor | Tuning Load Balancer parameters
Load Balancer Binary logging
You may switch on binary logging for analyzing server information that has been gathered over time.
To start binary logging, right-click Manager and select Start Binary Logging. To stop binary logging, right-click Manager and select Stop Binary Logging.
You may configure binary logging by clicking Advisor: Protocol Port and selecting Configurations settings in the right pane (see 19.2.7, Advisor).
The following information is stored in the binary log for each server defined in the configuration:
- Cluster address
- Port number
- ServerID
- Server address
- Server weight
- Server total connections
- Server active connections
- Server port load
- Server system load
Some of this information is retrieved from the executor as part of the manager cycle. Therefore, the manager must be running in order for the information to be logged to the binary logs.
Refer to "Using binary logging to analyze server statistics" in Load Balancer Administration Guide, GC31-6858, for more information about binary logging.
xxxx