Home

 

Stopping a channel initiator

 

To stop a channel initiator using the MQSC commands, use STOP CHINIT.

Using the operations and control panels, starting from the initial panel, complete these fields and press Enter:

Field	Value
Action	7 (Stop)
Object type	SYSTEM
Name	Blank

The Stop a System Function panel is displayed. The text following the panel explains how you should use this panel:

Figure 1. Stopping a function control

                             Stop a System Function

 Select function type, complete fields, then press Enter to stop system
 function.

 Function type . . . . . . . . _     1. Channel initiator
                                     2. Channel listener
 Action queue manager  . . . : MQ25

 Channel initiator
    Restart shared channels    Y  Y=Yes, N=No

 Channel listener
    Inbound disposition  . . . Q  G=Group, Q=Qmgr
    Transport type . . . . . . _  L=LU6.2, T=TCP/IP

    Port number (TCP/IP) . . . _____
    IP address (TCP/IP)  . . . ________________________________________________




 Command ===> ________________________________________________________________
  F1=Help      F2=Split     F3=Exit      F9=SwapNext F10=Messages F12=Cancel

Select function type 1 (channel initiator) and press Enter.

The channel initiator will wait for all running channels to stop in quiesce mode before it stops.

If some of the channels are receiver or requester channels that are running but not active, a stop request issued to either the receiver’s or sender’s channel initiator will cause it to stop immediately.

However, if messages are flowing, the channel initiator waits for the current batch of messages to complete before it stops.

 

Parent topic:

Managing your channels

ic14620_

 

Home