Prepare channels and transmission queues for remote administration
To run MQSC commands remotely, set up two channels, one for each direction, and their associated transmission queues. This example assumes that you are using TCP/IP as the transport type and that you know the TCP/IP address involved.
The channel source.to.target is for sending MQSC commands from the source queue manager to the target queue manager. Its sender is at source.queue.manager and its receiver is at target.queue.manager. The channel target.to.source is for returning the output from commands and any operator messages that are generated to the source queue manager. You must also define a transmission queue for each channel. This queue is a local queue that is given the name of the receiving queue manager. The XMITQ name must match the remote queue manager name in order for remote administration to work, unless you are using a queue manager alias. Figure 1 summarizes this configuration.
Figure 1. Setting up channels and queues for remote administration
See WebSphere MQ Intercommunications for more information about setting up channels.
Parent topic:
Remote administration from a local queue manager
fa11680_
Home
