Update the group membership configuration on AIX
When you configure LDAP user registry, a group membership is automatically created. You may need to adjust the group membership configuration if you notice high loads on the LDAP server and/or long response times on authentication requests.
In single server environments, you do not have to start or stop the WebSphere_Portal and server1 servers to complete the following steps. In clustered environments, stop all application servers on system, including WebSphere_Portal, then start the nodeagent and dmgr servers before you begin any of the following steps.
To update the group membership configuration:
If you created clustered environment then performed the steps in this task, now run the update-jcr-admin task on the secondary node. See Enable LDAP security after cluster creation for instructions.
- Edit WP_PROFILE/ConfigEngine/properties/wkplc.properties
- Update the following required parameters in wkplc.properties under the VMM LDAP group member config heading:
gc.ldap.id
gc.name
gc.updateGroupMembership
gc.scope
- Save changes to wkplc.properties.
- Run the ./ConfigEngine.sh wp-create-ldap-groupconfig -DWasPassword=foo task, from the WP_PROFILE/ConfigEngine, to update the group membership for the LDAP user registry.
- Stop and restart the appropriate servers to propagate the changes.
Parent
Update user registry on AIX
Related tasks
Start and stop servers, dmgrs, and node agents
Enable LDAP security after cluster creation