cleanupNode command

The cleanupNode command cleans up a node configuration from the cell repository. Only use this command to clean up a node if you have a node defined in the cell configuration, but the node no longer exists. You must run this command from the $WAS_HOME/bin directory of a Network Deployment installation.

 

Syntax

The command syntax is as follows

cleanupNode <node name> <deploymgr host> <deploymgr port> [options]
where the first argument is required.

 

Parameters

The following options are available for the cleanupNode command...

-quiet Suppresses the progress information that the cleanupNode command prints in normal mode.

-trace Generates trace information into a file for debugging purposes.

 

Usage scenario

The following examples demonstrate correct syntax

cleanupNode node
cleanupNode node -trace