Using the CallReply mode

The most common and simple pattern for using a Connector in CallReply mode is:

1. Using the Config Editor, add a Connector in CallReply mode to our workspace. See Creating a Connector. Very few Connectors support this mode.

2. Set the mode (CallReply) and other connection parameters for this Connector in the Connection tab; required parameters are marked with an asterisk (*). Some Connectors require you to configure a Parser as well in the Parser tab.

3. Set up the Output Attribute Map; see Output Attribute mapping.

4. Set up the Input Attribute Map; see Input Attribute mapping.

Keep in mind that Attributes from the Output Map are supplied to the connected system as input parameters; and Attributes mapped through the Input Attribute map contain the reply from the connected system.

Parent topic: CallReply mode