Using the AddOnly mode

The most common and simple pattern for using a Connector in AddOnly mode is:

1. Using the Config Editor, add a Connector in AddOnly mode to our workspace. See Creating a Connector.

2. Set the mode (AddOnly) and other connection parameters for this Connector in the Connection tab; required parameters are marked with an asterisk (*). Some Connectors require you to configure a Parser as well in the Parser tab.

3. Set up the Attribute Map; see Output Attribute mapping.

If you did not create the Connector directly inside an AssemblyLine, then to use the Connector in an AssemblyLine, drag it from its location in <workspace>/Resources/Connectors to the Flow section of the AssemblyLine.

Work entry attributes we have mapped are output to the connected system when the Connector is called by the AssemblyLine.

Parent topic: AddOnly mode