Using the AddOnly mode
The most common and simple pattern for using a Connector in AddOnly mode is:
- Using the Config Editor, add a Connector in AddOnly mode to your workspace. See Create a Connector.
- Set the mode (AddOnly) and other connection parameters for this Connector in the Connection tab; required parameters are marked with an asterisk (*). Some Connectors require you to configure a Parser as well in the Parser tab.
- Set up the Attribute Map; see Output Attribute mapping.
If you did not create the Connector directly inside an AssemblyLine, then to use the Connector in an AssemblyLine, drag it from its location in <workspace>/Resources/Connectors to the Flow section of the AssemblyLine.
Work entry attributes you have mapped are output to the connected system when the Connector is called by the AssemblyLine.
Parent topic:
AddOnly mode