IBM Tivoli Monitoring > Version 6.3 Fix Pack 2 > Installation Guides > Installation Guide > Set up event forwarding to Netcool/OMNIbus > Customize Event Integration
IBM Tivoli Monitoring, Version 6.3 Fix Pack 2
Change the configuration values of the IBM Tivoli Monitoring Situation Update Forwarder
After installation of IBM Tivoli Event Synchronization, you can change the configuration values of the Situation Update Forwarder that were specified during installation.
See Table 1 and Table 2 for the list of configuration values that can be modified. Use the procedure in this section to change the configuration parameters of the IBM Tivoli Monitoring Situation Update Forwarder when you are using the bidirectional architecture.
To change any of the settings for the IBM Tivoli Monitoring Situation Update Forwarder on the Netcool/OMNIbus ObjectServer system, use the sitconfig.sh command on Linux/UNIX or the sitconf.cmd command on Windows. You have two options for running this command:
- Manually modify the IBM Tivoli Monitoring Situation Update Forwarder configuration file for event synchronization (named situpdate.conf by default and located in <event_sync_install_dir>/etc) and then run: sitconfig.sh update <config_filename>.
- Run the sitconfig.sh command directly, specifying only those settings that you want to change.
See the for Tivoli Netcool/OMNIbus commands for the full syntax of this command.
After you change the configuration of the event synchronization, you must manually stop and restart the IBM Tivoli Monitoring Situation Update Forwarder process from the <event_sync_installdir>/bin directory. On a Windows operating system, use the stopSUF.cmd and startSUF.cmd commands. On operating systems such as UNIX, use the stopSUF.sh and startSUF.sh commands.
Parent topic:
Customize Event Integration