Stop the test

A running test may be stopped by clicking on the Stop button in the toolbar. The test is halted in 6 steps:

• Each Load Generator stops running its Virtual Users.
• Post monitoring: NeoLoad collects the performance counters for the duration defined.
• Collection of runtime information in debug mode for the Virtual Users concerned.
• Shutting down of the Load Generators.
• Calculation of the test statistics: this step may take several minutes, depending on the test duration. The progress bar shows the progress of the calculations. This step may be halted manually by clicking the Stop button again. Any statistics that could not be calculated due to this interruption will have a value of -1. All other statistics will be correct.
• Generation of the results summary: the Controller reads the statistics and generates the summary.

Once these steps have been completed, the Results section is displayed.

Home