server task jmt
The server task jmt command clears or loads the junction mapping table data.
Requires authentication (administrator ID and password) to use.
server task instance-webseald-host jmt load
server task instance-webseald-host jmt clear
Options
- instance-webseald-host
- Full server name of the installed WebSEAL instance. Specify in the exact format as displayed in the output of the server list command.
The instance_name specifies the configured name of the WebSEAL instance. The webseald designation indicates the WebSEAL service performs the command task. The host_name is the name of the physical machine where the WebSEAL server is installed.
For example, if the configured name of a single WebSEAL instance is default, and host machine name where the WebSEAL server is installed is abc.ibm.com, the full WebSEAL server name is default-webseald-abc.ibm.com.
If an additional WebSEAL instance is configured and named web2, the full WebSEAL server name is web2-webseald-abc.ibm.com.
- jmt clear
- Clears the junction mapping table data.
- jmt load
- Loads the junction mapping table data, which is located in the jmt.conf file. This file does not exist by default, so we must create the file and add data.
Authorization
Users and groups that require access to this command must be given the s (server administration) permission in the ACL that governs the /WebSEAL/host_name-instance_name/ object. For example, the sec_master administrative user is given this permission by default.
Return codes
- 0
- The command completed successfully. For WebSEAL server task commands, the return code will be 0 when the command is sent to the WebSEAL server without errors. Even if the command was successfully sent, the WebSEAL server might not be able to successfully complete the command and can return an error message.
- 1
- The command failed. When a command fails, the pdadmin command provides a description of the error and an error status code in hexadecimal format (for example, 0x14c012f2).
See "Error messages" in the IBM Knowledge Center which provides a list of the ISAM error messages by decimal or hexadecimal codes.
Examples
The following example loads the junction mapping table data from the jmt.conf file so that WebSEAL has knowledge of the new information:pdadmin> server task default-webseald-abc.ibm.com jmt load
Output is similar to:
JMT table successfully loaded.
See also
server task reloadParent topic: Command reference