server task jmt

Clears or loads the junction mapping table data.

Requires authentication (administrator ID and password) to use.

server task instance-webseald-host jmt load

server task instance-webseald-host jmt clear

Options

clear

Clears the junction mapping table data.

instance-webseald-host

Full server name of the installed WebSEAL server instance. Specify in the exact format as displayed in the output of the server list command.

The instance_name specifies the configured name of the WebSEAL server instance. The webseald designation indicates the WebSEAL service performs the command task. The host_name is the name of the physical computer where the WebSEAL server is installed.

For example, the configured name of a single WebSEAL server instance is default. The host computer name where the WebSEAL server is installed is abc.ibm.com. Then, the full WebSEAL server name is default-webseald-abc.ibm.com.

If an additional WebSEAL server instance is configured and named web2, the full WebSEAL server name is web2-webseald-abc.ibm.com.

load

Loads the junction mapping table data, which is in the jmt.conf file. This file does not exist by default, so we must create the file and add data.

Authorization

Users and groups that require access to this command must be given the s (server administration) permission in the ACL that governs the /WebSEAL/host_name-instance_name/ object. For example, the sec_master administrative user is given this permission by default.

Return codes

0

The command completed successfully. For WebSEAL server task commands, the return code is 0 when the command is sent to the WebSEAL server without errors. However, even after the command was successfully sent, the WebSEAL server might not be able to successfully complete the command. The WebSEAL server returns an error message.

1

The command failed. When a command fails, the pdadmin command provides a description of the error and an error status code in hexadecimal format (for example, 0x14c012f2).

See "Error messages" in the IBM Knowledge Center. This reference provides a list of the ISAM error messages by decimal or hexadecimal codes.

This command is available only when WebSEAL is installed.

For more information about the WebSEAL junction mapping table, see the Administering topics in the IBM Knowledge Center.

Example

The following example loads the junction mapping table data from the jmt.conf file. As a result, WebSEAL has the new information:

pdadmin> server task default-webseald-abc.ibm.com jmt load

Output is like:

JMT table successfully loaded.

See also

server task reload

Parent topic: pdadmin commands