Changing remote bus resource names

 

After you determine which buses control remote disk units, use Hardware Service Manager to change the resource names of the remote buses.

To change the resource names of the remote buses, perform these steps:

1. From the DST Main Menu, select Start a service tool.

2. From the Start a Service Tool display, select Hardware service manager.

3. From the Hardware Service Manager menu, select Logical hardware resources.

4. From the Logical Hardware Resources menu, selection System bus resources.

5. On the Logical Hardware Resource on System Bus panel, type 2 by the bus whose name you want to change. This displays the Change Logical Hardware Resource Detail panel.

6. On the Change Logical Hardware Resource Detail Panel, on the line labeled New resource name, change the resource name by adding the letter R to the beginning of the resource name of the bus. For example, change BUS08 to RBUS08. Press Enter to change the resource name.

7. Repeat this procedure for each remote bus on the system.

 

Parent topic:

Managing mirrored protection