Changing TFTP attributes

 

To change the Trivial File Transfer Protocol (TFTP) server attributes, use the Change TCP/IP TFTP Attributes (CHGTFTPA) command.

The following are two different ways to get to this command prompt:

You must have *IOSYSCFG special authority to make changes to the TFTP attributes with the CHGTFTPA command.

Figure 1. Change TFTP Attributes (CHGTFTPA) – Display 1 
                        Change TFTP Attributes (CHGTFTPA)
 
 Type choices, press Enter.
 
 Autostart server . . . . . . . .   *NO           *YES, *NO, *SAME  Enable subnet broadcast  . . . .   *YES          *YES, *NO, *SAME  Number of server jobs:    Minimum  . . . . . . . . . . .   2             1-20, *SAME, *DFT    Maximum  . . . . . . . . . . .   6             1-250, *SAME, *DFT  Server inactivity timer  . . . .   30            1-1440, *SAME, *DFT  ASCII single byte CCSID:    Coded character set identifier   00819         1-65532, *SAME, *DFT  Maximum block size . . . . . . .   1024          512-65464, *SAME, *DFT  Connection response timeout  . .   60            1-600, *SAME, *DFT  Allow file writes  . . . . . . .   *NONE         *DFT, *NONE, *CREATE...
 Alternate source directory . . .   '*NONE'  
 
 
 
 
                                                                         More...
 F3=Exit   F4=Prompt   F5=Refresh   F12=Cancel   F13=How to use this display  F24=More keys
Figure 2. Change TFTP Attributes (CHGTFTPA) – Display 2 
                         Change TFTP Attributes (CHGTFTPA)
 
  Type choices, press Enter.
 
  Alternate target directory . . .   '*NONE'

 

Parent topic:

Trivial File Transfer Protocol