cleanupNode command

The cleanupNode command cleans up a node configuration from the cell repository. Only use this command to clean up a node if you have a node defined in the cell configuration, but the node no longer exists. For more information about where to run this command, see the Using command tools article.

Syntax

The command syntax is as follows:

cleanupNode <node name> <deploymgr host> <deploymgr port> [options]

Parameters

The following options are available for the cleanupNode command:

-quiet

Suppresses the progress information that the cleanupNode command prints in normal mode.

-trace

Generates trace information into a file for debugging purposes.

-profileName

Defines the profile of the Application Server process in a multi-profile installation. The -profileName option is not required for running in a single profile environment. The default for this option is the default profile. The -profileName parameter specifies the deployment manager profile to run the command against. Because the dmgr profile is not the default profile, specify this parameter.

Usage scenario

The following examples demonstrate correct syntax:

cleanupNode myNode -profileName dmgr 
cleanupNode myNode -trace -profileName mydmgr