addUserToBusConnectorRole command

Use the addUserToBusConnectorRole command to add a user to the connector role for a local bus. To run the command, use the AdminTask object of the wsadmin scripting client.

This command is valid only when used with WAS V7.0 appservers. Do not use it with earlier versions. Command-line help is provided for service integration bus commands:

• For a list of the available service integration bus security commands in Jython and a brief description of each command, enter the following command at the wsadmin prompt:

  print AdminTask.help('SIBAdminBusSecurityCommands')

• For overview help on a given command, enter the following command at the wsadmin prompt:

  print AdminTask.help('command_name')

After using the command, save the changes to the master configuration; for example, by using the following command:

AdminConfig.save()

 

Purpose

Use the addUserToBusConnectorRole command to add a user to the bus connector role for a local bus. This command grants the user permission to connect to local destinations.

 

Target object

None.

 

Required parameters

-bus busName

The name of the local bus. Use the listSIBuses command to list the names of existing buses.

-user userName

The name of a user you want to add to the bus connector role for the local bus.

 

Conditional parameters

None.

 

Optional parameters

-uniqueName uniqueName

Specify the name that uniquely defines the user in the user registry. If an LDAP user registry is in use, the unique name is the distinguished name (DN) for the user. We can specify values for both -uniqueName and -user, but verify they identify the same user. The command does not check that the values match.

 

Example

The following example adds a user called User1 to the bus connector role for a bus called Bus1.

AdminTask.adduserToBusConnectorRole ('[-bus Bus1 -user User1]')

   

---

Last updated Nov 10, 2010 8:23:07 PM CST