rdqmint (add or delete floating IP address for RDQM)

Add or delete the floating IP address used to connect to a high availability replicated data queue manager (HA RDQM).


Purpose

Use the rdqmint command to add or delete the floating IP address that is used to connect to an HA RDQM regardless of which node in the high availability (HA) group is actually running the RDQM. (This command is not applicable to disaster recovery RDQM configurations.)


Syntax

rdqmint -mqmname-a-fipv4address-linterfacename-mqmname-d


Optional parameters

    -m qmname
    Specify the name of the RDQM for which we are adding or deleting a floating IP address.

    -a
    Specify this option to add a floating IP address.

    -d
    Specify this option to delete a floating IP address.

    -f ipv4address
    The IP address in dot decimal format.

    The floating IP address must be a valid IPv4 address that is not already defined on either appliance, and it must belong to the same subnet as the static IP addresses defined for the local interface.

    -l interfacename
    The name of the physical interface that the floating IP address is bound to.


Examples

To specify a floating IP address for the queue manager RDQM1, enter the following command:
rdqmint -m RDQM1 -a 192.168.7.5 -l MQCLI
To delete the floating IP address for the queue manager RDQM1, enter the following command:
rdqmint -m qmname -d
Parent topic: IBM MQ control commands reference