Control archiving and logging

We can control compression, printing, archiving, recovery and logging with using the CSQ6LOGP, CSQ6ARVP, and CSQ6SYSP macros. Note, that changes to private objects only are logged in IBM MQ logs. Changes to GROUP objects (like shared inbound channels) are also logged, because the definitions are propagated around the group and held locally.

Many aspects of archiving and logging are controlled by parameters set using the CSQ6LOGP, CSQ6ARVP and CSQ6SYSP macros of the system parameter module when the queue manager is customized. See Tailor the system parameter module for details of these macros.

Some of these parameters can be changed while a queue manager is running using the IBM MQ MQSC SET LOG, SET SYSTEM and SET ARCHIVE commands. They are shown in Table 1:

SET command	Parameters
LOG	WRTHRSH, MAXARCH, DEALLCT, MAXRTU, COMPLOG
ARCHIVE	All
SYSTEM	LOGLOAD

We can display the settings of all the parameters using the MQSC DISPLAY LOG, DISPLAY ARCHIVE and DISPLAY SYSTEM commands. These commands also show status information about archiving and logging.

Control log compression

We can enable and disable the compression of log records using either

• The SET and DISPLAY LOG commands in MQSC; see The MQSC commands
• Invoking PCF interface. See Introduction to IBM MQ Programmable Command Formats
• Use the CSQ6LOGP macro in the system parameter module; see Use CSQ6LOGP

Printing log records

We can extract and print log records using the CSQ1LOGP utility. For instructions, see The log print utility.

Recovering logs

Normally, we do not need to back up and restore the IBM MQ logs, especially if we are using dual logging. However, in rare circumstances, such as an I/O error on a log, you might need to recover the logs. Use Access Method Services to delete and redefine the data set, and then copy the corresponding dual log into it.

Parent topic: Manage the logs