How to find network attributes

The local node has been partially configured as part of the IBM® i installation. To display the current network attributes enter the command DSPNETA.

If you need to change these values use the command CHGNETA. An IPL might be required to apply your changes.

Display Network Attributes
System:  AS400PU
Current system name . . . . . . . . . . . . . . :  AS400PU
Pending system name . . . . . . . . . . . . . :
Local network ID . . . . . . . . . . . . . . . . :  NETID
Local control point name . . . . . . . . . . . . :  AS400PU
Default local location . . . . . . . . . . . . . :  AS400LU
Default mode . . . . . . . . . . . . . . . . . . :  BLANK
APPN node type . . . . . . . . . . . . . . . . . :  *ENDNODE
Data compression . . . . . . . . . . . . . . . . :  *NONE
Intermediate data compression . . . . . . . . . :  *NONE
Maximum number of intermediate sessions . . . . :  200
Route addition resistance . . . . . . . . . . . :  128
Server network ID/control point name . . . . . . :  NETID    NETCP
  
  
  
  
  
More...
Press Enter to continue.
  
F3=Exit  F12=Cancel

Check that the values for Local network ID (1), Local control point name (2), and Default local location (3), correspond to the values on your worksheet.